DIY Portable Solar Power Generator Part 6

Share it with your friends Like

Thanks! Share it with your friends!

Close

In part 6 of my video series I install a bus bar and rewire the DC power outlets (12V outlet & USB outlet) to eliminate the use of the insulation displacement wire taps (ScotchLoks) initially used to make connections. The 12V DC loads will also be connected to the load out terminals of the solar charge controller to take full advantage of its low voltage discharge protection feature. Here’s a link to the updated wiring schematic:
http://creeksideartifacts.com/PSG0717schematic.pdf

Comments

Comments are disabled for this post.